1. General
This document presents instructions for authors who are preparing a manuscript to submit to Journal of Innovative Science and Engineering (JISE). Manuscripts for consideration should be submitted to the Editorial Manager via online system (Dergipark) once you have read the author guidelines below.
Submission of a manuscript implies that the work has been submitted only to JISE; that it has not been previously published, nor it is under consideration for publication or in press elsewhere; that its publication has been approved by all co-authors. JISE will not be held legally responsible if authors fail to follow this condition.
1.1 Article Type
JISE publishes scientific research articles. Research articles should report results of an original scientific study where conclusions are based on significant findings after thorough evaluation of the topic.
The manuscript should be compiled in the following order: title page (including title, author’s affiliations, abstract, keywords); main text (introduction, materials and methods, results and discussion, conclusion); acknowledgements (funding and grant-awarding bodies); references; supplemental material (as appropriate).
Review articles can only be published upon invitation from the editor in chief to the renown expert in the field.
1.2 Format
The manuscript should be prepared on MS Word processor, in single line spaced using Times New Roman font on an A4 format with margins of 1.5 cm from all sides. All pages should be numbered consecutively. Manuscripts will not exceed 30 printed pages including; title page, main text, acknowledgements, tables and figures, and references.
1.3 Language
The manuscripts are accepted in English. It is the responsibility of the author to assure that the article is written in a clear and concise language. Manuscript submitted in poor quality and insufficient English will be rejected during pre-evaluation process. If English is not your native language, you may want to have your manuscript edited by a native speaker prior to submission.
2. Title Page
2.1 Title
Title should be written using bold type and Times New Roman font size 14 with lower case letters and center aligned. The title should be concise and informative, yet the number of words in the title should be limited to those words that highlight the significant content of the article. The title should not contain less common acronyms.
2.2 Author Information
Leaving one line after title, name(s) of author(s) should be written using bold type Times New Roman font size 11 with capital letters for the first letters of the words with center aligned, adding superscript numbers (i.e. 1, 2, 3) at the end of last name of each author. Corresponding author should be indicated with asterisk.
Leaving one line after name(s) of author(s), their affiliations and postal address should be written using Times New Roman font size 10 with capital letters for the first letters of the words with left alignment. The e-mail address should be also given for corresponding author in affiliation line. The format specified in the
''template file'' should be
followed while submitting the article.
2.3 Abstract and Keywords
The Abstract should be written using Times New Roman font size 10 and justified. The Abstract of 300 words should state the objectives and results of the work described. The Abstract should not contain any undefined abbreviations. Leaving one line after Abstract, there should be up to six keywords with capital letters for the first letter of each keyword using Times New Roman font size 10. Mathematics and references are not permitted in the abstract.
3. Main Text
The main body of the text should comprise “Introduction”, “Materials and Methods”, “Results and Discussion” and “Conclusion” sections. One line after each section should be left and text should be started leaving one line after section headings.
Introduction: It should contain the problem being researched, give an overview of earlier studies on the subject, and define the state of current studies. Please also state briefly and clearly the purpose of writing the article.
Materials and Methods: This section should present materials used in the study and the research procedure in detail.
Results and Discussion: The results of the study and the discussion should be grouped together, although sometimes, these sections are to be separate chapters. Results and Discussion should contain synthesis and discussion concerning previous studies on the subject. The corresponding tables and pictures should be provided in this section. However, the same data must not be displayed in two ways, e.g. graphically and in a table.
Conclusion: This section should summarize the main findings and also link to the recommendations.
Main section headings and subheadings should be written using bold type Times New Roman size 11 with capital letters for the first letter of each word in headings. The headings should be numbered consecutively (i.e. 1. Introduction, 2. Materials and Methods, 2.1 Study Area …). The sub-headings should be limited to three levels.
Scientific names in the article (such as plant and animal names) should be in italics. Internationally accepted signs and symbols should be used for units (SI units). Abbreviations should be defined at first mention and used consistently thereafter. Footnotes can be used to give additional information, which may include the citation of a reference included in the reference list.
4. Acknowledgements
Acknowledgments of people, grants, funds, etc. should be placed in a separate section at the end of the main text before the reference list. The names of funding organizations and grant-awarding bodies should be written in full.
5. Tables and Figures
All tables and figures are to be numbered using Arabic numerals and always be cited in the text in consecutive numerical order (i.e. Figure 1, Table 1 …). Tables and figures should be embedded in proper places in the text. The table and figure captions are to be written in Times New Roman font size 10. Any previously published material should be identified by giving the original source in the form of a reference at the end of the captions.
The content of the tables and figures should be in a Times New Roman font size 10. For tables and figures, the maximum width and height is 14 cm and 20 cm, respectively. Photos or pictures in the figures should have a minimum resolution of 300 dpi. The authors can use color art in tables and figures free of charge. Tables should not contain vertical lines. Figure parts are to be denoted by lowercase letters (a, b, c …). Do not include titles or captions within your figures.
6. References
The references should only include works that are cited in the manuscript and that are published or accepted for publication. Unpublished results and information obtained through articles and personal communications are not recommended for use as the reference. Reference entries should be listed in alphabetical order by the last names of the first author of each work. Abbreviated journal names and book titles can be used in references. Parenthetical citation should be: (Tutar & Çamlibel, 2010; World Health Organization, 2018; Grady et al., 2019; Lipscomb, 2021). Narrative citation should be: Tutar and Çamlibel (2010), Zambrano (2016) and Evans et al. (2019). All citations must be made according to the APA style shown below:
For a Journal Article
Lipscomb, A. Y. (2021). Addressing trauma in the college essay writing process. The Journal of College Admission, (249), 30–33.
Tutar, Ü., & Çamlibel, F. (2008). The conceptual dimensions of the consumer perception of value affecting consumer preference. Balıkesir University Faculty of Economics and Administrative Sciences Journal, 3(1), 47–58.
Grady, J. S., Her, M., Moreno, G., Perez, C., & Yelinek, J. (2019). Emotions in storybooks: A comparison of storybooks that represent ethnic and racial groups in the United States. Psychology of Popular Media Culture, 8(3), 207–217.
For a Book and a Chapter
Sapolsky, R. M. (2017). Behave: The biology of humans at our best and worst. Penguin Books.
Aron, L., Botella, M., & Lubart, T. (2019). Culinary arts: Talent and their development. In R. F. Subotnik, P. Olszewski-Kubilius, & F. C. Worrell (Eds.), The psychology of high performance: Developing human potential into domain-specific talent (pp. 345–359). American Psychological Association.
For a Report
National Cancer Institute. (2019). Taking time: Support for people with cancer (NIH Publication No. 18-2059). U.S. Department of Health and Human Services, National Institutes of Health.
For a Congress or a Symposium Proceedings
Evans, A. C., Jr., Garbarino, J., Bocanegra, E., Kinscherff, R. T., & Márquez-Greene, N. (2019, August 8–11). Gun violence: An event on the power of community [Conference presentation]. APA 2019 Convention, Chicago, IL, United States.
For a Thesis
Zambrano, L. (2016). The interaction of state and trait worry on response monitoring in those with worry and obsessive-compulsive symptoms [Doctoral dissertation, University of Arizona]. UA Campus Repository.
For an Electronic Source (Web documents)
World Health Organization. (2018, May 24). The top 10 causes of death. https://www.who.int/news-room/fact-sheets/detail/the-top-10-causes-of-death
Bologna, C. (2019, October 31). Why some people with anxiety love watching horror movies. HuffPost. https://www.huffpost.com/entry/anxiety-love-watching-horror
7. After Acceptance
Upon acceptance of your manuscript, you will receive the proofs to check for typesetting or conversion errors and the completeness and accuracy of the text, tables and figures. At this stage, extensive changes in content (e.g. new results, corrected values, title and authorship) are not allowed. After receipt of the corrected proofs, the article in PDF format will be published online.
December 15, 2025
Page
154-170
